¶ Introduction
After receiving your 22 IDEX, it's important to test its functionality to ensure nothing was damaged during shipping. This guide will walk you through the initial movements and checks to verify the proper operation of your machine.
Before proceeding, ensure the power button is connected and functional. Be ready to press it immediately if anything goes wrong during the homing process to avoid damaging your machine.
¶ Step-by-Step Guide
Check the Power Button:
- Ensure the power button works properly - to power on it need's to be pushed with turning, for power off - just pushed.
- Be prepared to press it if anything goes wrong during the homing process.
Connect to the Web Interface:
- Open your machine's web interface and navigate to the Dashboard.
Home the Y-Axis:
- Select
Home Yon the Dashboard. - The machine will move the crossbar to the front, where both Y-axis end stops are located in the front left and right corners.
- The Y-axis will home, ensuring the squareness of the motion system.
- The machine will then move the crossbar to the other end, preparing for homing the other axes.
Home the X-Axis:
- Select
Home Xto home the X-axis. - The left-hand side tool will move to the left and home using the end stop.
Home the U-Axis:
- Select
Home Uto home the U-axis. - The right-hand side tool will move to the right and home using the end stop.
Home the Z-Axis:
- Select Home Z on the Dashboard.
- The build plate will start to raise.
- Observe the build plate: Ensure all three corners are raising evenly.
- The build plate will eventually touch the Z-probe, which should trigger it to stop the movement.
Warning: Be ready to press the power button immediately if the build plate continues to move after contacting the probe or if anything else seems incorrect during Z-homing.
Troubleshooting Tip: If you hear a grinding sound and the build plate refuses to move upwards during this step, the Z-axis motors might be misaligned. This can happen during shipping or setup. For instructions on how to correct this, please refer to the Z - Motor Alignment Guide.
Home All Axes:
- Select
Home allto home all axes simultaneously and level the build plate. - This step ensures the overall alignment and readiness of your machine.
By following these steps, you will verify that your 22 IDEX is functioning correctly after shipping. If you encounter any issues or if something doesn't seem right, do not hesitate to contact our support team via email or phone for assistance.